TM-T81
Specification
(STANDARD)
<Function 12> GS ( E pL pH fn a (fn = 12)
[Name] Transmit the configuration item for the serial interface
[Format] ASCII GS ( E p
L pH fn a
Hex 1D 28 45 p
L pH fn a
Decimal 29 40 69 p
L pH fn a
[Range] (p
L + pH × 256) = 2 (pL = 2 , pH = 0)
fn = 12
a = 1
[Description] • Transmits the configuration item for the serial interface specified by a.
a Configuration item
1 Transmission speed
GS ( H pL pH fn [parameters]
[Name] Request transmission of response or status
[Description] • Various processes are performed for the response.
• pL, pH specify (pL + pH × 256) as the number of bytes after pH (fn and [parameters]).
• fn specifies the function.
• [parameters] specify the process of each function.
fn
Format
Function
No.
Function name
48
GS ( H p
L pH fn m d1 d2 d3 d4
48 Set the process ID response.
[Note] • Do not use this command in a system that uses the printer with the OPOS driver or
the JavaPOS driver provided by Seiko Epson Corporation.
<Function 48> GS ( H pL pH fn m d1 d2 d3 d4 (fn = 48)
[Name] Set the process ID response
[Format] ASCII GS ( H p
L pH fn m d1 d2 d3 d4
Hex 1D 28 48 p
L pH fn m d1 d2 d3 d4
Decimal 29 40 72 p
L pH fn m d1 d2 d3 d4
[Range] (pL + pH × 256) = 6 (pL =6 , pH = 0)
fn = 48
m = 48
32 ≤ d ≤ 126
[Description] • Saves the process ID specified by (d1, d2, d3, d4) for the data processed just before
this function.
To Next Page
Loading...
