Basic Settings
Select the menus on the control panel as described below.
Settings > General Settings > Fax Settings > Basic Settings
Fax Speed:
Select the fax transmission speed. We recommend selecting Slow(9,600bps) when a communication
error occurs frequently, when sending/receiving a fax to/from abroad, or when you are using an IP
(VoIP) phone service.
ECM:
Automatically corrects errors in the fax transmission (Error Correction Mode), mostly caused by
telephone line noise. If this is disabled, you cannot send or receive documents in color.
Dial Tone Detection:
Detects a dial tone before starting to dial. If the printer is connected to a PBX (Private Branch
Exchange) or digital phone line, the printer may fail to start dialing. In this situation, change the Line
Type setting to PBX. If this does not work, disable this feature. However, disabling this feature may
drop the rst digit of a fax number and send the fax to the wrong number.
Line Type:
Select the line type to which you have connected the printer. When using the printer in an environment
that uses extensions and requires an external access code, such as 0 and 9, to get an outside line, select
PBX and register the access code. Once you have registered the access code, enter # (hash) instead of
the access code when sending a fax to an outside fax number. For an environment that uses a DSL
modem or terminal adapter, setting to PBX is also recommended.
Header:
Enter your sender name and fax number. ese appear as a header on outgoing faxes. You can enter up
to 40 characters for your name, and up to 20 digits for your fax number.
Receive Mode:
Select the receive mode.
DRD:
If you have subscribed to a distinctive ring service from your telephone company, select the ring
pattern to be used for incoming faxes. e distinctive ring service, oered by many telephone
companies (the service name diers by company), allows you to have several phone numbers on one
phone line. Each number is assigned
dierent
ring pattern. You can use one number for voice calls and
another for fax calls. Depending on the region, this option may be On or O.
Rings to Answer:
Select the number of rings that must occur before the printer automatically receives a fax.
Remote Receive:
When you answer an incoming fax call on a phone connected to the printer, you can start receiving the
fax by entering the code using the phone.
User's Guide
Faxing
146
To Next Page
Loading...
Need help?
General
