Epson WF-C5710

337
Code Condition/solution
314 The data size exceeds the maximum size for the attached files. Increase the Attached
File Max Size setting in the Scan Settings menu on your product or lower the file size of
the scanned image.
315
327
The memory is full. Retry after other ongoing jobs have finished.
322 An authentication error occurred. Check the Location settings in your scan destination or
contact.
323 A communication error has occurred. Check the Location settings in your scan
destination or contact, or check the network connection.
324 A file with the same name already exists in the specified folder. Delete the duplicate file or
change the file name prefix in the Scan Settings > File Settings menu.
325
326
There is not enough storage space available in the specified folder. Increase the storage
space in the specified folder, delete unnecessary files, or lower the file size of the
scanned image.
328 The destination was wrong or the destination does not exist. Check the Location settings
in your scan destination or contact.
331 A communication error occurred. Make sure the product is connected to the network
correctly.
332 There is not enough space available for saving the scanned files in the specified folder.
Delete unnecessary files from the specified folder.
333 The destination could not be found because the destination information was uploaded to
the server before sending the scanned data. Select the destination again.
334 An error occurred while sending the scanned data.
341 A communication error has occurred. Make sure the product is connected to the computer
or network correctly. Make sure you have installed Document Capture or Document
Capture Pro. If the problem cannot be cleared, contact your product administrator.
405 An error occurred while saving data to an external USB memory device. Reinsert the USB
memory device or use a different USB memory device on which you created a folder
using the Create a folder to save fax data setting.
422 An authentication error has occurred. Make sure the settings are correct for the folder
selected in Settings > General Settings > Fax Settings > Receive Settings >
Save/Forward Settings.