EQUIL MTM-I - Page 58

Equil
TM
Insulin Patch Pump System
53
5
Push the pullrod slowly to eject the
bubbles back into the vial or cartridge,
and then slowly pull to draw more insulin
into the reservoir. Repeat until the reservoir
has enough insulin and there are no visible
air bubbles (Figure 63).
Figure 63
6
Remove the insulin vial or cartridge from
the fill adapter (Figure 64).
Figure 64
7
Pull the two release tabs (shown in
Figure 65) away from the reservoir to
release the fill adapter.
Figure 65
The fill adapter contains a needle,
please dispose of properly.
Note