Equil
TM
Insulin Patch Pump System
Note
b) If this is not your first time using the
wizard to connect a pump, the wizard will
start with Figure 71, as displayed on the
next page. Remove the pump and reservoir
from the pump base as shown in Figure 71.
Remove the old infusion set (Section 7.2),
apply a new one (Section 7.1) and press
Continue. The next page will prompt you to
deactivate your old pump (Figure 72).
Press Continue to disconnect the old pump
from the PDA and wait for the pump to
rewind. Separate the used reservoir from the
pump (Section 7.5), dispose of the old
reservoir and then assemble a filled reservoir
and a charged battery to the pump as shown
in Figure 70 on previous page. Press Continue
to go to the next page.
To Next Page
Loading...