Installing the RMM
4 Installing the RMM
Do!
Attention: Risk of system malfunction or traffic disturbance.
The O&M port is sensitive to moisture. Any operations involving opening the
O&M port must be performed in dry conditions. The O&M plate must always be
closed after accessing the MINI-LINK 6351.
Caution!
Electrostatic Discharge (ESD) may damage the equipment. Always use an
approved ESD wrist strap to avoid damage to components fitted on printed
circuit boards.
To install an RMM in a MINI-LINK 6351:
1. On the O&M plate, loosen the left-hand screw.
1313/1531-HRA 901 17/9 Uen B | 2016-03-04
To Next Page
Loading...
