Ericsson MINI-LINK 6351 - Optimizing the Antenna Alignment

Installing a MINI-LINK 6351
13. Tap Take photo to store a photo of the finished alignment. The photo is
stamped with the current date and time, and stored in the mobile device
for future reference.
7.3 Optimizing the Antenna Alignment
The following procedure assumes that:
• The antenna is already aligned using the alignment camera.
• The radio link is configured according to Configuring Radio Link.
You can optimize the antenna alignment in the following ways:
• Using Commissioning Guide.
• Using a voltmeter, described in this section.
The voltmeter is used to measure and find the maximum alignment value
during the alignment procedure.
To optionally achieve a more exact alignment, do as follows on both sides of
the hop:
1. Turn on the far-end transmitter:
end; config slot1 ct 1 far tx-admin-status on
2. Turn off the near-end transmitter:
end; config slot1 ct 1 near tx-admin-status off
Note: This command ensures that the ATPC function in the far-end
transmitter uses the maximum output power configured for the hop.
52
13/1531-HRA 901 17/9 Uen B | 2016-03-04