Ericsson MINI-LINK 6351 - Clamping the Poe Cable

Installing the MINI-LINK 6351
3. If an Ethernet surge protector is used:
a. Connect the PoE cable RJ45 connector to the Ethernet surge
protector.
b. Connect the Ethernet cable to the Ethernet surge protector.
c. Connect the Ethernet cable to the PoE injector.
If not using an Ethernet surge protector, connect the PoE cable Ethernet
connector to the PoE injector.
5.4.6 Clamping the PoE Cable
It is recommended to clamp the cables to the mast. The recommended
maximum distance between clamps is 1.0 m (40").
31
13/1531-HRA 901 17/9 Uen B | 2016-03-04