Installing a MINI-LINK 6351
C
6 Nm ±10%
4.4 ft-lb ±10%
6 mm
5. Smear the butyl sealing compound on the grooves between the PoE cable
and earthing kit body.
8751
6. Connect the other end of the earthing cable to mast ground.
5.4.8 Fitting the Wall Gland
The wall gland installation is to be performed from the outside of the building
and is only applicable for the cables that are to be connected to an indoor unit.
1. Make a hole through the wall.
2. Pull the cable through.
38
13/1531-HRA 901 17/9 Uen B | 2016-03-04
To Next Page
Loading...
