EROAD ELD - Certifying and Logging Out

2322
3.3 Changing drivers
The Active Driver must change his duty status to ON Duty ,
Sleeper Berth or OFF before changing drivers on the
EROAD ELD, when a co-driver is present. Perform the following
steps before the vehicle is in motion when you change drivers.
1 Tap the Driver icon on the Home menu.
2 The Logged In Drivers screen displays the Active Driver’s
name on the left side and the Co-Driver’s name on the right
side of the screen. Tap the Switch Driver icon.
3 Enter the active driver’s PIN.
4 Tap the Yes button. A confirmation message appears.
Note: See 2.1Logging into the ELD if you made a mistake and
recorded driving time for the wrong driver.
3.4 Changing vehicles
1 Tap ON or OFF at the Home screen in the first
vehicle to change your duty status. (See 2.4Changing your
duty status.)
2 Perform the logout procedure in the first vehicle. (See
3.9Finishing your day / Logging out.)
3 Perform the login procedure on the EROAD ELD in the
second vehicle and set your duty status.
3.5 Viewing and sending messages
Dispatchers can send messages to drivers through Depot.
Drivers can view and send messages using the Messages icon
on the Home menu. An orange light illuminates on the ELD
when a message is unread.
Unread messages are highlighted in orange.
● Read messages are highlighted in gray.
● Replies are highlighted in blue.
Caution
The vehicle must be stopped before you reply
or send a message.
1 Tap the Messages icon on the home screen. The alert
on the icon indicates a message is unread.
2 Tap the New Message button to send a reply.
3 Enter the message in the text field using the keypad.
4 Tap the Send button to send the message.
3.6 Reviewing logs
The EROAD ELD lets you quickly verify that your logs are
accurate and complete.
1 Tap the Logs icon on the Home menu. The Logs screen
displays activity for the current day.