TABLE OF CONTENTS
0460 949 474 © ESAB AB 2021
7.12 AC balance
..............................................................................................
26
7.13 AC offset
..................................................................................................
26
7.14 Flux pre-flow (SAW)
................................................................................
26
7.15 Gas pre-flow (GMAW)
.............................................................................
26
7.16 Start adjust
..............................................................................................
26
7.17 Air pre-flow (Gouging)
...........................................................................
27
7.18 Start type
.................................................................................................
27
7.19 Wire creep start
......................................................................................
27
7.20 Start phases
............................................................................................
27
7.21 Max Open Circuit Voltage (OCV)
...........................................................
27
7.22 Flux post-flow (SAW)
..............................................................................
27
7.23 Gas post-flow (GMAW)
...........................................................................
28
7.24 Air post-flow (Gouging)
.........................................................................
28
7.25 Crater filling
............................................................................................
28
7.26 Burnback time
........................................................................................
28
7.27 Stop phases
............................................................................................
28
7.28 Dynamic regulation
................................................................................
28
7.29 Control parameters
................................................................................
29
7.30 Setting limits
...........................................................................................
29
7.31 Measure limits
........................................................................................
29
7.32 PEK control unit as separate motor control
........................................
29
8
MEMORY MANAGEMENT
..........................................................................
33
8.1 Control panel working method
..............................................................
33
8.2 Store
........................................................................................................
33
8.3 Recall
.......................................................................................................
34
8.4 Delete
.......................................................................................................
35
8.5 Copy
.........................................................................................................
36
8.6 Name
........................................................................................................
37
8.7 Edit
...........................................................................................................
37
9
CONFIGURATION MENU
............................................................................
39
9.1 Code lock
................................................................................................
39
9.1.1 Lock code status .................................................................................. 39
9.1.2 Specify/edit lock code........................................................................... 40
9.2 General configuration
............................................................................
40
9.2.1 Fast mode soft keys ............................................................................. 40
9.2.2 Quality data log to file........................................................................... 41
9.2.3 Soft key configuration........................................................................... 41
9.2.4 Auto save mode ................................................................................... 43
9.3 Machine configuration
...........................................................................
43
9.3.1 Product code ........................................................................................ 44
9.3.2 Wire feed axis....................................................................................... 45
9.3.3 Cold wire axis (ICE).............................................................................. 46
To Next Page
Loading...
