Manual 0463 413 001 DECLARATION OF CONFORMITY 5
EU DECLARTION OF CONFORMITY
According to
The Low Voltage Directive 2014/35/EU, entering into force 20 April 2016
The EMC Directive 2014/30/EU, entering into force 20 April 2016
The RoHS Directive 2011/65/EU, entering into force 2 January 2013
Type of equipment
Welding power source
Type designation
EMP 215ic, from serial number 615 xxx xxxx (2016 w/21)
Brand name or trade mark
ESAB
Manufacturer or his authorised representative established within the EEA
Name, Address, and telephone No:
ESAB AB
Lindholmsallén 9, Box 8004, SE-402 77 Göteborg, Sweden
Phone: +46 31 50 90 00, Fax: +46 584 411 924
The following harmonised standard in force within the EEA has been used in the design:
EN 60974-1:2012, Arc Welding Equipment - Part 1: Welding Power Sources
EN 60974-5:2013, Arc Welding Equipment - Part 5: Wire Feeders
EN 60974-10:2014, Arc Welding Equipment - Part 10: Electromagnetic Compatibility (EMC) requirements
Additional Information:
Restrictive use, Class A equipment, intended for use in location other than residential
By signing this document, the undersigned declares as manufacturer, or the manufacturer's authorised
representative established within the EEA, that the equipment in question complies with the safety require-
ments stated above.
Date Signature Position
To Next Page
Loading...
