SECTION 1 PCM-875A Mechanized Plasma Cutting System SAFETY
1-9
1.7 Service Precautions
WARNING
!
Hazardous voltages. Electric shock
can kill.
· Do NOT touch plasma torch, cutting table or
cable connections during plasma cutting process.
· Always turn power off to plasma power
supplies before touching or servicing plasma torch.
· Always turn power off to plasma power
supplies before removing covers or panels to
service any system component.
· Do not touch live electrical parts.
· Keep all panels and covers in place when
machine is connected to power source.
· Keep gloves, shoes, clothing, work area, and
equipment dry.
· Inspect power and ground leads cables for
wear or cracking. Replace worn or damaged
cables. Do not use if damaged.
· Never bypass safety interlocks.
· Follow lock-out procedures.
WARNING
!
Hot Torch can cause skin burns.
Allow torch to cool before servicing.
To Next Page
Loading...
