SECTION 1 PCM-875A Mechanized Plasma Cutting System SAFETY
1-3
1.3 General Safety Information
NOTICE
Some subjects listed are not related specifically to
the type of equipment covered in this manual.
However, the safety principles still apply. They are
offered as a reminder that this equipment or
related apparatus should be operated with
alertness and understanding. Safety of operators,
technicians, maintenance workers and observers
should not be taken for granted.
WARNING
!
Machinery may start automatically.
Equipment positioning mechanized plasma torch
moves in various directions and speeds.
· Moving machinery can crush.
· Only qualified personnel should operate or
service this power source.
· Keep all personnel, materials, and equipment
not involved in production process clear of
entire system area.
· Fence off entire work cell to prevent personnel
from passing through area or standing in the
working envelope of the equipment.
· Post appropriate WARNING signs at every
work cell entrance.
· Follow lockout procedure before servicing any
equipment.
WARNING
!
Failure to follow operating instructions
could result in death or serious injury.
Read and understand this operator’s manual
before using machine.
· Read entire procedure before operating or
performing any system maintenance.
· Special attention must be given to all hazard
warnings that provide essential information
regarding personnel safety and/or possible
equipment damage.
· All safety precautions relevant to electrical
equipment and process operations must be
strictly observed by all having system
responsibility or access.
· Read all safety publications made available by
your company.
To Next Page
Loading...
