SECTION 3 PCM-875A Mechanized Plasma Cutting System Installation
3-19
1 Air Supply
2 Wall Disconnect Switch (Grounded)
3 PCM-875A Power Supply Cable
4 Work Cable (Negative)
5 Pilot Arc Cable
6 Gas Connection
7 Power Supply Cable
8 115 V High Frequency Start Cable
9 RAS Input Bulkhead
10 Remote Arc Starter
11 RAS Output Bulkhead
12 Pilot Arc Cable
13 Power/Gas Hose
14 Torch Lead Bundle Shield Ground
15 PT-20 AMX Plasmarc Torch
16 Work Cable Clamp
17 Work Piece
18 Earth Ground
19 ATAS Start/Stop CSR
20 CSR Cable
21 Height Control Cable (Voltage Divider)
22 Voltage Divider (Height Control)
To Next Page
Loading...
