3
2
1
2.
3.
4.
5.
6.
7.
8.
9.
10.
EAS
TM
For all types of materials. This cycle offers a more sophisticated edging mode than the standard cycle, specifically for
thin or small lenses and hydrophobic lenses.
Type of finish
Bevel
Customized bevel
Groove
Customized groove
Flat-edge
Flat-edge and drilling
Existing drilling disabled
To access the drilling preparation screen
Edging mode
Automatic mode
The finish parameters are automatically calculated according to the information acquired when tracing the frame and
feeling the lens.
Customized mode
The finish settings can be fully customized.
Polishing
Polished lens
Non-polished lens
Front surface chamfering
Small chamfer
Large chamfer
No chamfering
Rear surface chamfering
Small chamfer
Large chamfer
No chamfering
Displaying the binocular view
Save the settings / Return to the centering screen
2. Edging settings
You can input the edging settings before calling up the shape onto the edger.
Both lenses are set simultaneously.
Press to select the lens material.
The configuration of the edging cycles depends on the type of material. An incorrect choice may result in material
damage.
Press to select the type of cycle.
Press to select the type of finish.
To Next Page
Loading...
