2
1
3
2
1
2
1
3
2
1
a. Creating a drilling point
Press to create a new drilling point.
Select the type of drilling (drill-hole, slot or notch).
Press on the shape at the spot where you want to position the drilling point.
Press to copy the drilling points from the nasal area to the temporal area and vice-versa.
On the tracer, you can configure up to 6 drilling points per side (nasal and temporal) of a shape.
Photo mode
After tracing a pattern, it is possible to retrieve the drill holes on the corresponding demo lens:
Position the demo lens (corresponding to the pattern) in the centering chamber, press .
For photo mode, it is not necessary to mark the lens, the posiblock can also be kept: it is a simple shot.
If the image is badly centered, repeat the operation.
Manually position the drill holes of the shape locating them using the photo.
The drilling point created is displayed in red in the shape:>
The drilling coordinates are displayed on the right of the work screen;>
The photograph of the demo lens appearsto be positioned correctly in the picture of the shape:>
To Next Page
Loading...
