Essilor Mr Blue 2.0 - Introduction

USER MANUAL > INTRODUCTION
Mr Blue 2.0 > v4.0 -09.16 7
INTRODUCTION
To benefit fully from the functions of your Mr. Blue 2.0 tracer-centerer-blocker, we highly recommend that you read the
documentation.
You have memory version: V9.0.0 (or higher)
Addition of a menu on the “tracing” page allowing you to set the insertion height of the feeler in the groove (specific to the
asymmetrical grooves: sport frames in particular)
Addition of a centering menu with re-marked micro-engravings for the single vision lenses: the prp is set by default at 0.
The “edging preparation screen” menu and the edger selection page associated with the product are accessible and
configurable on the customization screen.
An Essibox button is available on all the products on the tracing, centering and finishing page.
The modification of IP settings is accessible: it is from now possible to configure the two DNS.
A new tracing mode for demo lenses is available .for the “Nylor” frame
If sphere and cylinder values are present in the job file, they are displayed on the screen in order to avoid the re-entering of
the values.