1.
2.
3.
4.
5.
6.
7.
1.
2.
Blocking arm autotests
Movements performed to test the operation of the blocking arm and clamps.
Vertical movement of the arm
Horizontal rotation of the arm
Rotation of the blocking head
Transfer of the blocking head
Opening and closing of the clamps
Optical autotests
Operations performed to test the operation of the centering function.
Select the autotest to be carried out.
Press to start the test cycle.
You can press to stop the cycle at any moment.
> The result is displayed on the right of the icon of the autotest carried out:
The equipment is operational.
A malfunction has been detected; a description is displayed in the message box on the right.
2. Checks and calibration
This section describes the procedures to follow if you notice mounting problems that may be due to tracing or centering operations.
Check the tracing table then calibrate it if required (p.122),
Check the centerer-blocker then calibrate it if required (p.124)
Calibrate the touch screen (p.125).
a. Checking and calibrating the tracing table
If you encounter mounting problems, you can check the calibration of the tracing table.
To Next Page
Loading...
