To stop centering at any time, press .
Lens fit check
A visual warning enables you to check the lens fit: any part of the lens outside the shape is displayed in red.
You can modify the PD and pupillary height to get the shape to fit into the lens, but if the induced prism is too great, we
advice you to order a new lens in the proper diameter.
To carry out lens blocking, refer to the section .Centering a lens > Blocking a lens (p.80)
c. Centering a bifocal lens in manual mode
Manual centering enables you to center the lenses which:
cannot be centered in automatic mode
cannot be centered automatically using the three focimeter dots
In this mode, the lens is centered in near vision.
Prerequisite: The lens must be marked with the focimeter.
The three focimeter dots must be:
Lined up
At the same distance from the central dot
0.5 to 1.5 mm in diameter
The lens analysis starts: the tracer searches for the optical characteristics of the lens.>
The centered lens is displayed in the work area:>
Yellow indicators are displayed on the focimeter dots: the centering is perfect.>
The lens is centered and ready to be blocked.>
To Next Page
Loading...
