1.
2.
3.
4.
5.
6.
1.
2.
This chapter describes the maintenance procedures you can carry out on the tracer-centerer-blocker without the help of a technician.
Performing tracer auto-tests (p.121)
Checking and calibrating the tracer (p.122)
and the display configuration Making a backup of the jobs (p.127) Ref. manquante (p.127) Ref. manquante (p.127)
“Remote control” Function (p.128)
Viewing the statistics and technical history (jobs and actions carried out) (p.131)
Maintain and clean the tracer (p.132)
1. Carrying out the autotests
This menu is used for auto-diagnosis of the tracer functions:
Tracing table
To test the operation of the tracing table, select > > from your work screen.
Tracing table autotests
Clamps
Vertical movement of the feeler
Rotation of tracer core
Displacement of tracer core
Feeler movement
Select the autotest to be carried out.
Press to start the test cycle.
You can press to stop the cycle at any moment.
> The result is displayed on the right of the icon of the autotest carried out:
The equipment is operational.
A malfunction has been detected; a description is displayed in the message box on the right.
Centerer-blocker
To test the operation of the centerer-blocker, select > > from your work screen.
To Next Page
Loading...
