6
5
4
3
2
1
If you want to save job A, refer to the .job creation procedure (p.24)
If you want to go back to job A after working on a saved job:
Scan barcode A using the barcode reader (optional), or
Use the numeric keypad and follow the procedure below.
In the tracing screen, press in the action bar to create a new job.
For further information on data input and use of the keypad, refer to the following section: First steps > First use of
.the tracer-centerer-blocker > Using the touch screen (p.14)
Select the list in which you want to store the job:
Press to select the job list.
Press to select the collection list.
For further information on the lists, refer to the section Tracing > Managing and storing shapes > Job list and
.collection list (p.24)
Press to enter the of the new job.ID
(p.148)
An ID is automatically allocated by the tracer (first free slot in the selected list). You can modify it: the ID can consist of
alphanumeric characters.
In the collection list, the ID solely consists of numeric characters.
Press to enter the reference of the new job.
Irrespective of the list selected, the reference may consist of alphanumeric characters. It can contain the information
of your choice:
Customer's name
Frame brand or reference
Manufacturer, etc.
Press to confirm.
Job list: Collection list:
The tracer is ready for tracing. For further information, refer to the section concerning your frame type.
The symbol is displayed is the upper right of the job ID if the right lens has been blocked but not the left.
3. Tracing a rimmed frame
Prerequisite:
For correct tracing of the shape, the frame to be traced must not be deformed and its hinges must be closed.
For a small frame, place the two wedges between the tracing table clamps:
The alphanumeric keypad is displayed.>
The tracing screen is displayed. The ID allocated and the symbol of the list in which the job is stored appear in the
information bar.
>
The symbol is displayed at the bottom right of the job ID as soon as the job is being modified. It disappears once the
job has been saved.
>
To Next Page
Loading...
