2
1
9.
10.
11.
12.
13.
14.
15.
16.
> Only jobs #1, #5 and #7 are selected.
Press to select a group of consecutive jobs in the list, then select the first and last job in the group.
Example: Press on the button then select jobs #1 and #10.
> All jobs from #1 to #10 are selected.
Press to select all jobs in the list.
Select all jobs
Press to select all jobs for the search in progress.
Delete the selected job(s)
Press to delete the selected job(s). A confirmation message is displayed.
Job list or collection list
Select the list to be displayed:
Job list
Collection list
Search for a job by ID or by reference
Rename the selected job
Duplicate the selected job
Call the selected shape to the work area
b. Job list
Two lists are available for the storage of shapes:
The job list
The collection list
You can copy a job from one list to the other via the button .
The job list
The job list enables you to save jobs on a daily basis, without the possibility of re-using them at a later date. It can store up to 1,000
jobs.
The collection list
The collection list enables you to save specific jobs, for subsequent re-use:
Recurrent jobs
Standard shapes
Drilling models
It can store up to 1,000 jobs. The barcode reader (optional) cannot be used to call or save a job in the collection list; only the numeric
keypad can be used for that purpose.
c. Creating a job
There are several ways of creating a job:
Scan the barcode corresponding to the desired ID using the barcode reader (optional): the job is saved to the job list.
To create a job, use the alphanumeric keypad and follow the procedure below.
In the tracing screen, press in the action bar to create a new job.
For further information on data input and use of the keypad, refer to the following section: First steps > First use of
.the tracer-centerer-blocker > Using the touch screen (p.14)
Select the list in which you want to store the job:
The alphanumeric keypad is displayed.>
To Next Page
Loading...
