3
2
1
For greater precision, when you use the virtual mouse or the buttons and , press to zoom in on the selected
drilling point: the displacement step is 0.01mm (0.1mm for normal display).
Press on the hole, slot or notch to select it.
Press a few seconds on the value corresponding to the coordinates to be modified:
X coordinates
Y coordinates
Distance from the edge of the lens.
X coordinates in relation to the reference drilling point
Y coordinates in relation to the reference drilling point
Freeze the distance to the edge of the lens and adjust only the Y position of the drilling point.
Enter the new value, then press to confirm.
The drilling point is displayed in red.>
The numeric keypad is displayed.>
The drilling coordinates have been modified.>
To Next Page
Loading...
