ES581.4 - User’s Guide 19
ETAS Getting Started
3 Getting Started
The "Getting Started” chapter describes the preparation of the installation, the
installation, the uninstallation as well as checking the installation of the USB driv-
ers and the J2534 drivers for the ES581.4. This chapter describes also the USB
and the CAN connection of the ES581.4.
3.1 Preparation
3.1.1 USB and J2534 Drivers
3.1.2 Checking System Requirements
Verify that your PC meets the system requirements (see chapter 5.2 on page 33).
To install the USB driver on the PC, you require the user rights of an administra-
tor. If necessary, contact your system administrator.
3.1.3 CD-ROM
The supplied CD-ROM includes:
• USB driver for the ES581.4 with installation wizard
• J2534 driver for the ES581.4 with installation wizard
• Hardware Service Pack (HSP) for updating the firmware
• Documentation: ES581.4 User's Guide (this document)
The application for installing the USB driver is in the root directory of the CD-
ROM as executable autostart.exe file.
Or you can install the driver via the supplement contained in the HSP (HSP
V10.4.0 and higher).
3.1.4 Installing Sequence
Installing the ES581.4 you have to work in this sequence:
1. USB driver installation (ES581.4 not connected on PC),
2. J2534 driver installation (For the first time installation it is not necessary
that the ES581.4 module should be unplugged from the PC. Once when
the module was detected by the PC, installation/un-installation cannot
proceed unless the device was disconnected.),
3. USB connection,
4. CAN connection.
A specific USB driver and an J2534 driver must be installed on the PC for oper-
ating the ES581.4 module.
Before connecting the ES581.4 to the USB port of your computer, the
driver install application must be run first.
To Next Page
Loading...
