ETAS ES581.4 - System Requirements (Software)

ES581.4 - User’s Guide34
Technical Data ETAS
Options for power management may be included in:
• the BIOS setup
• the Windows Control Panel (e.g. Power object).
5.2.2 Software
Supported Applications and Software Prerequisites
To operate the ES581.4 and for data acquisition purposes software in the follow-
ing versions or higher is required:
Note
If you have stringent requirements for your application time management
(time-driven transmission of messages, time-driven evaluations), you must
deactivate these power managers.
Note
This document does not look at the deactivation of power managers in any
further detail.
Application /
Protocol
Classifi-
cation
INCA V7.0 INCA V7.1 Add-On
ODX-LINK
CAN Monitoring MC
1)
V7.0.0 HF25 V7.1.5 -
CAN Output MC
1)
V7.0.0 HF25 V7.1.5 -
CCP MC
1)
V7.0.0 HF25 V7.1.5 -
KWP on CAN MC
1)
V7.0.0 HF25 V7.1.5 -
UDS MC
1)
V7.0.0 HF25 V7.1.5 -
XCP on CAN MC
1)
V7.0.0 HF25 V7.1.5 -
OBD-on-CAN MC, DS
2)
V7.0.0 HF25 
V7.1.5
V1.4.2
4)
,
V1.5.5
5)
CAN MC, PTI
3)
V7.0.0 HF25 V7.1.5 -
ISO15765 MC, PTI
3)
V7.0.0 HF25 V7.1.5 -

1)
: MC: Measurement and Calibration
2)
: MC, DS: ECU Diagnosis
3)
: MC, PTI: SAE J2534-1 Pass Thru Interface
4)
: INCA V7.0.0 HF25 and higher and additional INCA Add-On ODX-LINK
V1.4.2 and higher
5)
: INCA V7.1.5 and higher and additional INCA Add-On ODX-LINK V1.5.5 and
higher