2 Source Four Assembly Guide
Assembling basic fixture
Step 1: Follow instructions under Assembling lamp socket, page 5.
Step 2: Follow instructions under Reflector Housing Assembly, page 8.
Step 3: Follow instructions under Shuttle Barrel Assembly, page 11.
Step 4: Assemble Lens Tubes following the instructions for your applicable lens degree
application.
Step 5: Insert lens tube assembly (8-16) fully into the front barrel assembly (6-7). Align
the mounting hole with the slot and secure with knob (17). See Figure 1.
Step 6: Install reflector housing (2-5) onto front barrel assembly (6-7) and align the two
mounting holes. Secure with screw (19) on top, and knob (17) on bottom. Tighten
both securely. See Figure 1.
Step 7: Install the lamp socket assembly (1) to the reflector housing (2-5) and secure with
brass knurled screw on rear of lamp socket assembly.
Step 8: Release the gel retaining clip by pushing it sideways while gently pulling
backwards.
Step 9: Insert the color frame.
Step 10: Lock the clip by pushing sideways while gently pushing it forward.
To Next Page
Loading...
