Ever SINLINE RT - Page 15

EVER UPS SINLINE RT / RT XL series instruction manual
15
www.ever.eu
Pomoc Techniczna, tel.: +48 61 6500 400
2017-04-26 12:41
Canceling
messages
Press the button to cancel the currently displayed message.
Increasing the value
of parameters
Press the button to increase the value of the edited parameter.
C
Scrolling down
Press the button shortly to scroll down between information screens.
Press the button shortly to navigate down the menu options.
Switching the sound
alarm on/off
Press and keep the button depressed for over 1 second to switch the UPS
unit's sound alarm on/off. The function is only accessible from information
screens.
Navigating to the
end of the submenu
Press and keep the button depressed for over 1 second to navigate to the
end of the submenu.
Decreasing the
value of parameters
Press the button shortly to decrease the value of the edited parameter.
Confirming
messages
Press the button shortly to confirm the currently displayed message.
Table 2. Sound and visual signaling of specific states of the UPS unit
Event
Sound signal
Visual signal
MAINS (normal) mode
No sound signal.
Green LED on.
BACK-UP (battery)
mode
Intermittent signal; frequency increases
proportionally to the level of discharging of
the batteries, until it turns into a continuous
sound. The alarm is only active if activated
(Configuration; Sound signal; Back-up mode)
and if the MUTE function is inactive.
Red LED on.
STANDBY mode
No sound signal
Red LED pulsating (100 ms ON / 5 s
OFF).
INI mode (initialization)
No sound signal
Red and green LED pulsating
intermittently (0.5 ms ON / 0.5 s
OFF).
EMERGENCY mode
Red LED pulsating (100 ms ON / 100 ms OFF) with sound alarm on (the signal is
switched on and off with the LED). The alarm is active even if the MUTE function is
inactive.