EverFocus EDR1640 - Page 110

100
 Note: Make sure the modem is in bridge mode. If your Internet Service Provider is
BellSouth you may have a modem/router. BellSouth provides a Westell modem
that includes a built-in router. You will need to disable the router functionality.
 The next step is to open ports within your router. Open virtual ports in the router (Log
into the router using a PC)
o EDR Ports to open: 80, 1600,1601,1602,1603, 37260, 37261, 37262, 37263
 Note: If your Internet service provider blocks port 80 you must use a different
port to access the DVR through the DVR’s Network Menu Setup.
 Note: If you wish to have multiple users log into the DVR please open a range for
the control and data ports on your router. For example if you would only like 4
clients to connect to the DVR open 1600-1603 and 37260 ~ 37263
 If you have a Dynamic IP address and have open the ports simply go to Chapter 13 to
Configure DDNS.
 Once you have reached this point and you have restarted the digital recorder.
 To access the DVR from a computer simply open Internet Explorer and in the address bar
type:
http:// and the IP address of your internet service provider.
 Note: If your Internet service provider blocks port 80 you may use a different
port to access the DVR through the DVR’s Network Menu Setup.