103
Application - In this field, enter the name you wish to give the application. Each name can
be up to 12 characters.
Start/End - This is the port range. Enter the number that starts the port range under Start
and the number that ends the range under End.
Protocol - Enter the protocol used for this application, either TCP or UDP, or Both.
IP Address - For each application, enter the IP Address of the PC running the specific
application.
Enable - Click the Enable checkbox to enable port forwarding for the relevant application.
Change these settings as described here and click the Save Settings button to apply your
changes or Cancel Changes to cancel your changes.
To Next Page
Loading...
