evertz XRF1 - Serial Control Port Configuration; Engineering; Debug

XRF1/XRF1A 16x16 RF Router Manual
XRF1 - 3-8 Revision 1.2 SERIAL PORT
3.7. SERIAL CONTROL PORT CONFIGURATION
The serial control port menu is used to set the configuration of the serial control port located on the rear of
the frame. It also displays the current settings stored in flash memory. This port is used to control the
routing matrix from external, third party control systems. This menu does not configure the
configuration/upgrade port located on the front edge of the frame controller card.
------------------------------------------------
| Serial Control Port Configuration |
| (XRF1-FC v1.00 b961) |
------------------------------------------------
------------------------------------------------
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop Bits: 2
Standard: RS 232
Protocol: Evertz Router Control
------------------------------------------------
(1) Set baud rate
(2) Set number of data bits
(3) Set parity
(4) Set number of stop bits
(5) Set standard
(6) Set protocol
(X) Exit
>
3.8. ENGINEERING / DEBUG
This menu contains several menu commands that are intended for use only by Evertz engineering staff.