XRF1/XRF1A 16x16 RF Router Manual
CONTROL PANEL OPERATION Revision 1.2 XRF1 - 5-7
Navigate to desired destination --- using the up/down arrow keys, the scroll knob,
or 0-9 numeric buttons
Depress the scroll knob --- enters Source Selection Mode
Navigate to desired source --- using the up/down arrow keys, the scroll knob,
or 0-9 numeric buttons
[TAKE] --- performs physical router connection between
“TELSTAR 12” and “IRD 16”
--- displays “TAKE SUCCESSFUL” for 2 seconds, then returns to
Destination Selection Mode
An example of how a salvo (named “ALL CALL SOURCE 5” – input channel 5 to all destinations) is
executed is as follows:
Navigate to desired salvo --- using the up/down arrow keys, the scroll knob,
or 0-9 numeric buttons
[TAKE] --- performs physical router connection between
input channel 5 and all destinations
--- displays “TAKE SUCCESSFUL” for 2 seconds, then returns to
Destination Selection Mode
"
After a “take” is completed, from any selection mode, the 16-character screen will
display a “TAKE SUCCESSFUL” message for 2 seconds. The display will then return
to the previous mode and display the last manipulated input/output pairing or salvo.
5.8. [ENTER] FUNCTION
5.8.1. [ENTER] Function from Destination Selection Mode
1. Navigate to desired destination
2. Press [ENTER]
Toggles to Source Selection Mode
"
NOTE: The [ENTER] key does not perform physical crosspoint changes. The [ENTER]
key cannot perform a [TAKE].
"
NOTE: Pressing [ENTER] while a salvo is selected is a NO OP. The [ENTER] key cannot
perform a [TAKE].
5.8.2. [ENTER] Function from Source Selection Mode
1. Navigate to desired source
2. Press [ENTER]
Toggles to Destination Selection Mode
"
NOTE: The [ENTER] key does not perform physical crosspoint changes. The [ENTER]
key cannot perform a [TAKE].
To Next Page
Loading...