evertz XRF1 - Crosspoints; Passcode; Mode; AGC Output Level

XRF1/XRF1A 16x16 RF Router Manual
SERIAL PORT Revision 1.2 XRF1 - 3-5
3.5.7. Crosspoints
This menu item displays the crosspoints and allows a crosspoint to be set by the user. An input of 0
indicates the output is not connected.
------------------------------------------------
| Crosspoints
| (XRF1-FC v1.00 b961)
|
------------------------------------------------
output input
------ -----
1 <--- 1
2 <--- 2
3 <--- 3
4 <--- 4
5 <---- 5
6 <---- 0
7 <---- 0
8 <--- -0
9 <---- 0
10 <--- 0
11 <--- 0
12 <--- 0
13 <--- 0
14 <--- 0
15 <--- 0
16 <--- 0
------------------------------------------------------------
(1) Set crosspoint
(X) Exit
>
3.5.8. Passcode
This menu item allows the user to view and reset the passwords for the user and the administrator.
3.5.9. Mode
Each input may be set to either manual or automatic gain control (AGC) mode. In manual mode, the gain
through the system on a particular input is fixed, and user specified (0 dB is the default). In automatic gain
control (AGC) mode, the output level on a particular input is fixed, to a user selected target (-20 dBm is the
default). The AGC maintains the output level if the input level is within the range determined by the AGC
output level and the available gain in AGC mode.
3.5.10. AGC Output Level
In AGC mode, each input has a target power output level, as seen by all outputs connected to that input.
The target power default is –20 dBm, but can be set from –20 dBm to –50dBm. The target output level is
maintained, if the input level is within the range determined by the AGC output level and the available gain
in AGC mode.