Raptor User Manual
2017 EverySight Ltd. Proprietary Page 6 of 46 Rev 1.0
Congratulations on purchasing your brand new Raptor Smartglasses. This Manual will help
you become familiar with the Raptor, and allow you to use them in the best manner
possible.
What’s in the Box?
Your Raptor comes wrapped in it’s hard carrying case along with:
1. A soft carrying case.
2. A Micro-USB wall charging unit.
3. A data cable.
4. A Quick start guide and safety instructions.
5. Grip enhancing adhesives.
Getting to Know Your Raptor
Note: Your Raptor comes with Grip Enhancing Adhesives that will help keep your glasses in
place and provide extra comfort. They should be placed on the inside of your Temple Arms
and over the proximity sensor as shown in the illustration below.
• These areas should be wiped off to ensure that no dust or dirt is present while
applying the adhesives
• The Grip Adhesive for that sits over the proximity sensor has space cut out so that
the sensor can still function properly, be sure it is aligned to rest against your
forehead without covering the proximity sensor
Charging Your Raptor
We send out your Raptor smartglasses partly charged and we recommend that you fully
charge them before your first ride.
When the battery is depleted, It should take about two hours to fully charge your Raptor.
When your Raptor is fully charged you'll have up to 8 hours of normal use.
To charge your Raptor, open the USB cover located on the end of your Raptor's left arm. Use
the provided Micro-USB wall charging unit and data cable.
To Next Page
Loading...