262
MIDSECTION
TILLER HANDLE SERVICE – LONG HANDLE
Disconnect trim switch connector. Remove con-
nector from trim switch wires. Refer to CONNEC-
TOR SERVICING on p. 148.
Use Twist-Grip Remover, P/N 390767, to depress
the grip detents. Tighten screw and remove the
grip by pulling grip.
Remove the helix halves, rollers, and guides.
Pull the throttle pin out of the cable.
Remove the throttle friction control.
Remove the throttle cable retaining clip. Pry the
cable trunnion out of the steering handle and
remove cable.
The trim switch wiring can now be removed from
the inner handle.
Remove the screw and washer retaining the inner
handle tab.
1. Twist-Grip Remover
2. Screw
006710
1. Helix halves
2. Rollers
3. Guides
COA2674
006712
1
2
1 2 3 2 1
1. Throttle friction control 006671
1. Retainer
2. Throttle cable trunnion
006674
006681
1
1
2
To Next Page
Loading...
