Available Copy Actions
The basic principle is that only copies to the local EVS server are possible, whereas
copies to a distant EVS server are not supported.
The following table provides an overview on the copy actions available from the Remote
Panel and from the VGA interface. The playlists are copied to an empty playlist position:
L = local playlist/position
D = distant playlist
Remote Panel VGA Interface
L to L D to L L to L D to L
EDL Copy
Yes Yes
Yes
Yes
EDL+Clips Copy (short or long) No
• To play back a selected clip, with the lever, at a speed varying from 0% to a given
maximum speed, you need to do the following:
◦ Define the requested maximum speed in the PGM Speed/Var max parameter
(p.9.1 F3) in the Operational Setup menu.
◦ Select (highlight) the VarMax option in the secondary menu in PGM/PRV mode.
In the Remote Panel Interface
To copy a playlist, proceed as follows:
1. Go to the source playlist bank (local or from another machine on the network).
2. Select the original playlist to copy by pressing the corresponding F_ key.
3. Go to the destination playlist bank.
4. Select an empty playlist location.
A new menu appears on the LCD display of the Remote Panel, with the corresponding
message on the OSD of the output monitors, asking whether you want to copy the
original playlist to the new location or whether you simply want to select a new, empty
playlist (default choice):
Select New Playlist 13 ?
[Menu]: Cancel
[Enter]: Confirm
COPY NEWPLST
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 89
To Next Page
Loading...
Need help?
General
