Circle Drawing (O)
To draw a circle, proceed as follows:
1. Select O on the Paint mode monitor display.
2. In the displayed menu, choose between the following options:
• Set center (default): A pointer appears on the screen to let you set the center of the
circle. The radius will be the one last used or the default one if none has been defined
before.
• Define: This option allows you to change the size of the circle.
Click on the Define menu and follow the instructions:
◦ Set the center of the circle.
◦ Set the radius.
You can then choose to save or not the new circle:
• ESC: no circle is drawn.
Ellipse Drawing (0)
To draw an ellipse, proceed as follows:
1. Select 0 on the Paint mode monitor display.
2. In the displayed menu, choose between the following options:
• Set center (default): a pointer appears on the screen to let you choose the center of
the ellipse. The shape will be the one last used or the default one if none has been
defined before.
• Define: allows you to change the shape of an ellipse, click on the Define menu and
follow the instructions:
◦ Set the left corner.
◦ Set the opposite corner.
You can then choose to save or not the new ellipse.
• ESC: no ellipse is drawn.
Arrow (A)
To add an arrow at the end of a line, proceed as follows:
1. Select A on the Paint mode monitor display.
2. When you draw on the tablet and remove the pen, a «neat» arrow appears at the end
of the line.
3. This option remains «on» until you select A again to turn it off.
184 9. Advanced Control Modes
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
