.
.
.
.
.
.
.
.
.
.
Pcs
.
.
.
.
.
.
.
.
.
.
Pcs
NET/GROSS FUNCTION
In the Tare mode, the screen displays the “Net” icon, press the NET/GROSS key to
switch between the “Net value” and the “Gross value”.
4 When the 6GROSS icon is on, the weight value on the display is the total
amount of the tare value and net value.
4 At the Gross status, only OFF and NET/GROSS keys are functional.
4 NET/GROSS key is only used in Tare mode.
SIMPLE COUNTING FUNCTION
(1) Use the UNITS key to enter into the “PCS” mode
(2) Press the NET/GROSS key to select the counting sample size
(S = 10, S = 20, S = 50, S = 100, S=200). The LCD shows , ,
, , in order.
(3) Put the samples on the weigh pan and press the UNITS key, the screen
displays “------”. After the sampling process is complete, put the goods on the
weigh pan and the screen shows the quantity of the items.
4 The sample weight should be heavier then the minimum capacity of the scale
(20d), If not the arrow pointing to the icon will be activated.
4 The weight of a sample should be heavier than the 0.2d (d=division), or the
arrow pointing to the icon will be on.
4 When the or are indicated the scale is still operational but the
count may contain errors.
4 To power off in this mode, the scale will memorize the “Pcs” unit. When the
scale is powered on again, it directly enters the simple counting mode.
4 While the “Auto unit weight average” function is available in the Advanced
Function, the goods on the weigh pan are 5pcs greater than the sample size
and less than double the sample size, the scale will automatically re-sample the
unit weight.
To Next Page
Loading...
Need help?
General
