Excell SI-132 - Continuous Transmission Setting

EXCELL PRECISION CO., LTD
SI-132 v1.1 SME300000081
26
2-5-4 Continuous Transmission Setting
Select in the RS232 serial interface setting mode
to set the Continuous Transmission Setting.
Transmission setting
LCD shows the last setting
4 Default setting:
Transmission setting
Use ON/ZERO or UNITS keys
to select the
transmission type:
= Command mode
= Continuous
transmission
= Constantly auto
transmission
= Shut down RS232
ACTIONS
DISPLAY
NOTE
Press TARE key
Use ON/ZERO or UNITS
keys to select the
transmission type
Press TARE key
Key in the parameter “00”
Press the TARE
key to exit
RS232 serial interface
settings
ON/ZERO key
⇒
Upward key (from 0 to 9)
UNITS key ⇒ Downward key (from 9 to 0)
TARE key ⇒ Move the cursor to right
NET/GROSS key ⇒ Move the cursor to left.