Excell SI-132 - Output Condition Setting

EXCELL PRECISION CO., LTD
SI-132 v1.1 SME300000081
30
2-5-8 Output Condition Setting
Select in the RS232 serial interface setting mode
to Reset of Auto Transmission.
Output condition setting
The LCD shows the last setting.
4 Default setting:
Output condition setting
Use ON/ZERO or UNITS keys to select the
desired setting:
= Output all the time
= Stable weight output only (No
output when under/overload or unstable)
Press TARE key
Use ON/ZERO or UNITS
keys to select the desired
setting
Press TARE key
Key in the parameter “00”
Press the TARE key to
exit RS232 serial interface
settings
ON/ZERO key
⇒
Upward key (from 0 to 9)
UNITS key ⇒ Downward key (from 9 to 0)
TARE key ⇒ Move the cursor to right
NET/GROSS key ⇒ Move the cursor to left.
ACTIONS
DISPLAY
NOTE