Excell SI-132 - Hold Function Setting

EXCELL PRECISION CO., LTD
SI-132 v1.1 SME300000081
19
2-3-6 Hold Function Setting
Select in the General Function setting mode to
set the hold function.
Hold function setting
Use ON/ZERO or UNITS keys to key in the
parameters
Default setting = 0
0 ⇒ Hold function disabled
1 ⇒ “Peak hold” mode
2 ⇒ “Stable hold 1” mode
3 ⇒ “Stable hold 2” mode
Hold function setting
LCD displays the last parameter setting
= Hold function disabled
= “Peak hold” mode
Keep displaying the maximum weight when the weight is continually changing
To exit this mode, press any key.
= “Stable hold 1” mode
When the weight is stable, the LCD shows the current weight value. To exit
this mode, press any key.
= “Stable hold 2” mode
When the weight is stable, the LCD shows the current weight value. When the
weight returns to zero (<10d), the hold mode is cancelled automatically.
Press TARE key
Use ON/ZERO or UNITS
key to key in the
parameters
Press TARE key
Key in the parameter “00”
Press TARE key to
complete the general
setting procedures
ACTIONS
DISPLAY
NOTE
ON/ZERO key
⇒
Upward key (from 0 to 9)
UNITS key ⇒ Downward key (from 9 to 0)
TARE key ⇒ Move the cursor to right
NET/GROSS key ⇒ Move the cursor to left.