E-7
3.2 Pre-Start Instructions
Before starting this machine it is important that the instructions below are
followed
1) Ensure that this manual is read & understood by the operator.
2) Do NOT attempt to start the machine until you are aware of ALL aspects of its operation.
Any questions should be referred to your supervisor.
3) Remove any temporary sealing and transport straps.
4) Check that the machine is in good mechanical condition and that there is no component
damage or loss.
5) Ensure all bolts and fixings are tight and that all guards are in place with all safety devices
operating correctly. NEVER start machine without guards and safety devices operating
correctly.
6) Ensure that the Feeder, Screenbox and Conveyors are all free of material.
7) Remove all tools and equipment from the operational area.
8) Ensure all personnel are well clear of the machine, drives, tracks and auxiliary equipment.
9) Ensure that the checks and pre-start procedures outlined in the engine manufacturers
instruction manual are complied with.
10) Check all fluid levels.
11) Safety pins are in appropriate positions.
12) Ensure all operating levers are in an off position.
13) Ensure that any skirting rubbers and scrapers are in good condition and working properly.
Section 3 Page 4
To Next Page
Loading...