1.7 Measured Noise Level
The above diagram indicates the measured noise levels at a measured distance.
i.e. 7M – 85dB indicates at 7 Meters the sound recorded was 85 decibels. The
readings were measured using a Castle GA101/701 meter with a calibration date of
13/9/94. with all systems running situated on the factory assembly line.
The product and local conditions will affect the noise levels
Ear Protection is compulsory within 10 Meters of the machine when the engine and all
other parts of the machine are running.
1.8 Vibration Levels
There are no circumstances where an operator needs to be on or touching this
equipment when it is running.
1.9 Organisational Safety Measures
x Understand the service procedure before doing work. Keep area clean and dry.
x Never lubricate, clean, service or adjust machinery while it is moving. Keep
hands, feet and clothing clear of power driven parts and in running nip-points.
Disengage all power and operate controls to relieve pressure. Stop the engine.
Implement lockout procedure. Allow the machinery to cool.
x Keep all parts in good condition. Ensure that all parts are properly installed. Fix
damage immediately. Replace worn and broken parts. Remove any build up of
grease, oil and debris.
x Disconnect battery ground cable before making adjustments on electrical
systems or welding on plant.
x During Maintenance only use the correct tool for the job.
x Never make any modifications, additions or conversions which might affect
safety without the manufacturers’ approval.
x In the event of safety relevant modifications or changes in the behaviour of the
plant during operation, stop the plant and lock out immediately and report the
malfunction to the competent authority/person.
1.10 Personnel Qualification, Requirements and Responsibilities
1.10.1 Any work on and/or with the plant must be executed by trained, reliable and
authorised personnel only. Statutory minimum age limits must be observed.
1.10.2 Work on electrical system and equipment of the plant must be carried out only
by a skilled electrician or by instructed persons under the supervision and
guidance of a skilled electrician and in accordance with electrical engineering
rules and regulations.
1.10.3 Work on the hydraulic system must be carried out only by personnel with
special knowledge and experience of hydraulic equipment.
To Next Page
Loading...