E-7
4.8 TROUBLE SHOOTING GUIDE
Below is a list of some of the common problems that might occur on your machine.
If these problems arise, carry out the checks listed.
Engine losing power or
hard to start.
Engine will not start or keeps
shutting off.
One or all of the Conveyor belts
is/are not running at the correct
speed.
Screenbox has excessive
vibration.
Machine 'rocking' excessively.
Machine not Tracking.
Check air filter is not blocked.
Check diesel filter and sediment bowl.
Check that emergency stops are not pushed in.
Check water level in radiator.
Check fuel level.
Check that batteries are charged and terminals
are tight.
Check oil pressure, temperature and battery
lights on control panel.
Check belt tension.
Check there is no build up of material around the
conveyor.
Check for blockages in hydraulic return and
suction filters.
Check that screen meshes are tight.
Check meshes for pegging. i.e trapped material.
Check machine is running at max. set operating
speed.
Check that screenbox is not colliding with Tail
conveyor.
Check ground conditions are firm and level.
Check tracks are not slack. If they are see page
35 for adjustment.
Check that track lever is in the ON position.
Check oil level in the hydraulic tank.
Check remote handset is fully charged - plug in
Hard Wire and try to move machine.
IF ANY PROBLEM PERSISTS AFTER CARRYING OUT THE RECOMMENDED SOLUTION, OR A
PROBLEM ARISES THAT IS NOT ON THIS LIST, CONTACT EXTEC SERVICE DEPARTMENT FOR
FURTHER ASSISTANCE.
PROBLEM
SOLUTION
Section 4 Page19
To Next Page
Loading...