Section 916
BENDIX/KING KT 76A Transponder
Page Date: 15. December 2005 916 - 5
Pilot´s Operating Handbook
EXTRA 300L
916.4 NORMAL PROCEDURE
After engine start-up, turn the function selector to the Standby (SBY) position. Then select the
proper reply code by rotating the code select knobs.
As soon as aircraft is airborne, switch the function selector to ON. Your KT 76A is now operating
in „Mode A“, or normal mode. To operate in „Mode C“, or altitude reporting mode, turn the function
selector to ALT (if aircraft is equipped with altitude encoding equipment).
916.4.1 SQUAWK IDENT
When you are asked to „ident“ by ATC, briefly press the IDENT push-button. Your aircraft will be
positively identified to the Air Traffic Controller.
916.5 PERFORMANCE
Not Applicable
To Next Page
Loading...
