Extreme Networks ExtremeSwitching VDX 6740 - Page 100

NOTE
The FlexPort feature allows conguration of specic ports as Ethernet or Fibre Channel ports, depending on installed
transceivers. Therefore, status LEDs may indicate GbE or FC port function. Refer to FlexPort on page 14 for more information.
FIGURE 64 LEDs on the port side of the VDX 6740
1. System power LED
2. System status LED
3. Device management Ethernet port link LED
4. Device management Ethernet port activity LED
5. Upper GbE SFP+ port status LED
6. Lower GbE SFP+ port status LED
7. Upper 40 GbE QSFP port status LED
8. Lower 40 GbE QSFP port status LED
FIGURE 65 LEDs on the port side of the VDX 6740T
1. Device management Ethernet port link LED
2. Device management Ethernet port activity LED
3. System status LED
4. System power LED
5. Upper 10G Base-T port status LED*
6. Lower 10G Base-T port status LED*
7. Upper QSFP port status LED*
8. Lower QSFP port status LED*
* Base ports on the VDX 6740T operate at 1 Gbps unless port upgrade license is applied to allow 10 Gbps.
The following illustration shows the LEDs on the non-port side of the VDX 6740T.
FIGURE 66 LEDs on the non-port side of the VDX 6740T
1. Fan assembly status LEDs 2. Power supply status LEDs
LED activity interpretation
ExtremeSwitching VDX 6740 Hardware Installation Guide
100 9036108-00