FIGURE 53 Rack kit parts
1. Front brackets (2)
2. Rear brackets, 3-5 inch post (2)
3. Rear brackets, 5-6 inch post (2)
4. Screw, 8-32 x 5/16-in., panhead Phillips (8)
5. Screw, 8-32 x 5/16-in., athead Phillips (16)
6. Screw, 6-32 x 1/4-in., panhead Phillips (8)
7. Screw, 10-32 x 5/8-in., panhead Phillips (8)
8. Retainer nut, 10-32 (8)
Ensure that the items listed and illustrated above are included in the kit. Note that not all parts may be used with certain installations
depending on the device type.
Flush-front mounting
Observe the following notes when using this procedure:
• The device must be turned o and disconnected from the fabric during this procedure.
• The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
• The illustrations for this procedure show a two-post rack with narrow posts (3- to 5-inch) as an example.
• The illustrations in the rack installation procedures are for reference only and may not show the actual device.
CAUTION
Use the screws specied in the procedure. Using longer screws can damage the
device.
Complete the following tasks to install the device in a rack:
1. Attaching the front brackets to the device on page 77
2. Attaching the front brackets to the rack on page 77
Installing the Universal Two-Post Rack Kit (XBR-R000294)
ExtremeSwitching VDX 6740 Hardware Installation Guide
76 9036108-00
To Next Page
Loading...
