4. Adjust the brackets to the rack depth and tighten the screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 34 Attaching the rear brackets to a rack
1. Bracket, front right
2. Retainer nut, 10-32
3. Screw, 10-32 x 5/8-in., athead Phillips
4. Bracket, rear right
Attaching the rear brackets to the device
Complete the following steps to attach the rear brackets to the device.
1. Align the right rear bracket to the right rear of the device and use two 8-32 x 5/16-in. screws to attach the bracket to the device
as shown in the following gure.
2. Align the left rear bracket to the left rear of the device and use two 8-32 x 5/16-in. screws to attach the bracket to the device as
shown in the following gure.
Installing the 1U, 1.5U, and 2U Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292)
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00 55
To Next Page
Loading...
