4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 25 Attaching the front brackets to the rear of the device
1. The device
2. Front brackets
3. Screws, 8-32 x 5/16-in., athead Phillips
Attaching the bracket extensions to the front of the device
Complete the following steps to attach the bracket extensions to the front of the device.
1. Position the right bracket extension along the side of the device as shown in Figure 26.
2. Insert four 8-32 x 5/16-in. athead screws through the vertically aligned holes in the bracket extension and then into the holes
on the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat step 1 and step 2 to attach the left front bracket extension to the left side of the device.
Flush-rear (recessed) mounting the device in the rack
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00 45
To Next Page
Loading...
