4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 59 Attaching front brackets to a rack
1. Screws, 10-32 x 5/8-in., panhead Phillips 2. Retainer nuts, 10-32
Attaching the rear brackets to the rack
Complete the following steps to attach the rear brackets to the rack.
1. Select the proper length bracket for your post width. If your posts are three to ve inches wide, use the brackets marked 3-5
INCH. If your posts are ve to six inches wide, use the brackets marked 5-6 INCH.
2. Position the right rear bracket in the right rear of the device, as shown in the following gure. Whether you are using the 3-5 inch
or the 5-6 inch bracket, the rear end of the bracket will be ush with the back of the device.
3. Attach the brackets to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left rack upright.
Installing the Universal Two-Post Rack Kit (XBR-R000294)
ExtremeSwitching VDX 6740 Hardware Installation Guide
82 9036108-00
To Next Page
Loading...
